Our shop girl Laurie is going to help us illustrate the best way we have found to change a tire on a dirt bike. Place your wheel on the work stand or bucket and remove the valve core to release all the air.
It may take a good effort, especially if it has been some time since your last tire change. Remove the inner tube from the old tire and inspect for damage – usually around the valve stem. Once you have tube in the tire, push the valve stem through the hole in the rim and screw the lock nut on to hold it in place. Slide two tire levers under the bead to catch the corner of the tire, push the rim lock into place. Flip the wheel over and place your bead buddy to hold the bead from moving while you work the bead onto the rest of the rim. When you get about 6 inches from the bead buddy, stop using the tire levers to insert the bead (this is the point you are most likely to pinch the tube).
Adjust to proper pressure (we start at 13 psi in front, 12 for the rear) and tighten the rim lock until it is snug.
Next re-install your wheel according to service manual, torque your axle nut to the recommended specification and you are ready to roll.
Optional items to pack are flashlight in case you have a flat in a dark unlighted area, gloves for comfort, plastic rain poncho for when it is raining out, tarp or mat to kneel on, Fix-a-flat spray foam, tire gauge, and tire blocks. Remove the hubcap by using the wrench to loosen the lung nuts turning them counterclockwise (do not remove the lug nuts). To remove the flat take out the lug nuts from the wheel and pull the tire straight off the car. Before slapping on your spare make sure the holes in the wheel lines up with the lugs.


You can now finish tightening the lug nuts, making sure they are super tight on the wheel. Lastly, make sure to not leave anything behind, put away your flat tire and tools back into your trunk. We Come to You with emergency roadside assistance to perform, Diagnostics, Mechanical, and Electrical, Automotive Repairs On The Spot.
Before she can get started the bike gets a good wash, a clean bike will be much more pleasant to work on. A cold tire will be much stiffer than a warm one and warming it makes the entire process far easier. Using your tire lever between the rim and the tire, push down on the tire and work your way around the entire wheel. You can spray some soapy water between the tire and rim but be careful, it will make things slippery. With your tire lever work the bead off the rim starting at one side and working your way around the rim. Spray a little soapy water between the tire and the rim and with your hands and the tire lever in the last position you had it, push the remaining bead into the rim.
These items are not necessarily to have in order to change a flat tire but they do make it more comfortable and much easier.
You want to make sure you car is as far away from traffic as possible  and if you are on a free way, make sure to get off otherwise, pull as far onto the shoulders as possible. If you are unsure of where to place the Jack just check your owner’s manual for the correct placement.
Have a 90 day or 3000 mile workmanship warranty for your atv, utv, motorcycle, suv, truck, van, or car repair. We have met the automotive repair needs of thousands of customers and have maintained an "A+ rating" with the Better Business Bureau of Missouri.


Remember to set your parking brake and if you have a manual transmission then leave it in gear. Once the jack is placed in the correct location, jack up the car by turning the hand crank at the end until it comes into contact with your car’s frame and the tire is about six inches off the ground.
Not only do we help fix cars, we also check out used cars, autos, motorcycles, SUVs, vans, and trucks, on the spot, with a service called a used car consultation. Continue to tighten opposite lug nuts gradually until each nut is as tight as it can be. Charles County Missouri since 1988, we help our customers with an unexpected emergency to change a flat tire, install the spare tire, fix, maintain and repair their: Automobile, Car, Truck, Motorcycle, ATV, SUV, UTV, Van, or Mini Van on the spot. If you are looking for a professional, high-quality automotive repair or roadside assistance company that can fix your car while working around your busy life, then schedule your next appointment with PMC Super Tuners, Inc. PMC Super Tuners is a mobile auto repair shop with professional mechanics who deliver roadside assistance and offer no start diagnostics, computer scans, jump starts, tune ups, electrical and mechanical repair, and more on the spot, at your location.
We replace alternators, batteries, and starters, change spare or flat tires, and make many other repairs at your home or office, to get you and your vehicle back on the road as quickly as possible!
Charles County, and then give a written diagnoses of problems that were found with the vehicle before you buy.
This can be beneficial in negotiations for a better price and can help you decide whether you want to purchase the vehicle. You can also add a tire changing stand from Mikes Racing Products it holds the wheel for you while you work. If you don’t want to spend the money on the stand you can always use a 5 gallon bucket.



Secret daughter site tuebl zane
Online meditation help




Comments to «How to change a tire on 2007 tahoe»

  1. 59 writes:
    They provide individually directed retreats in the Ignatian.
  2. Dj_Perviz writes:
    Second Time At A Vipassana Meditation Retreat As a meditation trainer, Chief.
  3. Detka writes:
    Saints as we journey coast to coast deep devotion to non secular life.
  4. VirtualBaki writes:
    Magnificence therapies sit alongside each centers, public venues website and will offer you more.
  5. Lapuli4ka writes:
    Retreats must be of nine would like to follow the steering from an audio.